Lennox Hearth G8 User Manual
Page 40
2. Find the power plug provided in the kitpack and
insert your vessel power wires into the plug’s (+)
and (-) terminals (see Figure 2-18).
3.
If you’ve routed an IRD ground wire to the MCU
(as recommended in
insert the wire into the plug’s
ground (-) terminal.
4. Secure the wires in place by tightening the
terminal screws.
5. After inserting and securing the wires, tug gently
to ensure that the connections are solid. Also make
certain that the wire insulation is not pinched in
the connector.
6. Plug the power connector plug into the power jack
7. Secure the plug in place with the two retaining
screws.
8. The MCU has a ground wire preattached to one of
its retaining screws (see Figure 2-19). Be sure to
connect this wire to a suitable ground.
Installation
54-0198
37
Figure 2-18
Power Plug
Figure 2-19
MCU Ground Wire