Lennox Hearth G8 - Manual (Page 32)

12. Using a 9 ⁄
16
" wrench, connect the RF cable(s) from
belowdecks to the baseplate. If you connect more
than one RF cable, label both ends of each RF cable
to match its antenna baseplate connector (RF1,
RF2, RF3, or RF4). Figure 2-10 shows an RF cable
connected to the RF1 connector.
13. Route the other ends of the data/power and RF
cables belowdecks (if mounting the antenna to the
deck, route the cables into the cable access hole
that you cut out in Step 4).
14. Place the rear logo plate over the cables, so that
each cable exits the proper opening (see
Figure 2-11). Using the six M4 screws supplied in
the kitpack, attach the logo plate to the baseplate
as shown in Figure 2-11.
15. Place the antenna baseplate over the mounting
holes drilled in the foundation, ensuring the
connectors face the stern.
Installation
54-0198 29
Figure 2-11
Attaching the Logo Plate
Do NOT use teflon gel on the cable
fittings as it reduces signal strength
at higher frequencies.
Figure 2-10
Connecting the RF1 Cable
RF3 RF1 RF2 RF4