Lennox Hearth G8 - Manual (Page 108)

5.13 Replacing the Elevation Motor
1. Disconnect the motor cable from the elevation
motor.
2. Remove the motor shield by pressing on the two
sides of the shield above the release tabs.
3. Remove the four #8-32 screws and washers
securing the motor to the antenna frame. Remove
the old elevation motor.
54-0198 110
TracVision G8 Owner’s Manual - Guide to Technical Information
Motor Cable
Connector
Figure 5-27
Elevation Motor Cable
Elevation Motor
Release Tab
Figure 5-28
Elevation Motor (Shield Removed)
#8-32 Screws
and Washers
(x 4)
Elevation Motor
Motor Hub
Elevation Belt