Lennox Hearth G8 - Manual (Page 60)

Using the MCU Interface
54-0198 59
3.1 Startup and Self-test
To turn on the TracVision G8, follow the steps below.
1. Turn on the IRD and television.
2. Apply operating power to the MCU.
3. Wait while the system initializes and searches for
the satellite.
The MCU displays the following screens during system startup:
KVH Industries, Inc.
TracVision G8
Init RF Board
SAT A Menu SAT B
Init Sensor
SAT A Menu SAT B
Init Antenna
SAT A Menu SAT B
** Search mode 1 **
SAT A Menu SAT B
** Search mode 2 **
SAT A Menu SAT B
** Search mode 3 **
SAT A Menu SAT B
Network ID Check
SAT A Menu SAT B
Init Rate Bias
SAT A Menu SAT B
To Main Display
Tracking <SAT NAME>
SAT A Menu SAT B
Entering Tracking
SAT A Menu SAT B
Antenna initializing
SAT A Menu SAT B
Limit Switch Test
SAT A Menu SAT B
Figure 3-1
TracVision G8 Startup Screens
“Search Mode” screens may not
appear during every startup.