Lennox Hearth G8 - Manual (Page 75)

Updating Satellite Frequency Data
If the antenna is unable to find a satellite, the satellite’s frequency
data may have changed. The Satellite Frequency Scan feature
allows you to update the frequency data of any satellite stored in
the system’s library.
This function should not be used unless directed by KVH
Technical Support or a KVH-authorized technician.
With the desired satellite, band, and polarization selected, the
system will automatically search for the frequency with the
strongest signal. The system will then update that satellite’s
programmed data with the new frequency (and associated
network ID) and store it in the satellite library.
To update the satellite frequency data, follow the steps below:
1. Place your IRD in the satellite signal meter mode.
2. Select the desired satellite on the MCU. Ensure the
TV signal meter indicates that you have a strong
signal.
If the antenna is unable to find the selected
satellite automatically, you can manually point the
antenna using the Manual mode (see “Manually
Controlling the Antenna” on page 69).
3. Select the desired polarization and band on the
IRD.
4. Do not move the vessel. Your boat must remain
motionless during the entire Satellite Frequency
Scan process.
5. Follow the MCU menus on the next page. The
scan itself will take a couple of minutes. Once
complete, restart the antenna and ensure the
antenna will track the new frequency.
54-0198 74
TracVision G8 Owner’s Manual - Guide to Technical Information
Do NOT use this function unless
directed by KVH Technical Support
or a KVH-authorized technician.
Improper data selection may affect
the system’s operation.