Lennox Hearth G8 - Manual (Page 78)

Using the MCU Interface
54-0198 77
Return to "Manually Controlling
the Antenna
Configure satellite?
Yes Next Return
Configure satellite
A B
Set Symb Rate: XXXXX M/S
- Enter +
Configure Symbol Rate?
Yes Next Cancel
Set Freq: XXXXX MHz
- Enter +
Configure Frequency?
Yes Next Cancel
Configure A <SAT NAME>?
Yes No
Configure B <SAT NAME>?
Yes No
Set ID: XXXXXX HEX
- Enter +
Configure FEC Code?
Yes Next Cancel
Set FEC Code: X/X
- Enter +
Configure Network ID?
Yes Next Cancel
Use the -/+ keys to set each digit of the number. Selecting
ENTER will cycle the display through each digit and then
display the next configuration screen. Note 2:
Use the -/+ keys to scroll through the available FEC codes:
1/2 - 2/3 - 3/4 - 5/6 - 6/7 - 7/8.
Use the ENTER key to accept your selection. Note 3:
Note 2
Note 2
Note 3
Note 2
Polarization: XXX
- Enter + Note 1
Use the -/+ keys to scroll through the available polarizations:
LHC - RHC - HH - HL - VH - VL.
Use the ENTER key to accept your selection. Note 1:
Figure 3-21
Configure Satellite