Lennox Hearth G8 - Manual (Page 68)

Antenna Status Data Screens
Figure 3-10 shows the information available through the Get
Antenna Status mode.
Using the MCU Interface
54-0198 67
Get bit error rate?
Yes Next Return
Bit error rate
#####
Push any Button to Proceed
Get Thres/sig level?
Yes Next Return
Proceed to "Control Antenna Mode"
Get Antenna status?
Enter Next Return
Get system errors?
Yes Next Return
Get Version?
Yes Next Return
Antenna ver = #.##
RF Ver = #.##
Get skew angle?
Yes Next Return
Skew angle
##.#
(If errors detected)
Signal level = ####
Threshold = ####
OR
No errors detected
Testing OK
Test <Test Type>
Testing Failure
Push any Button to Proceed
Push any Button to Proceed
Push any Button to Proceed
Get serial number?
Yes Next Return
Antenna serial #
########
Push any Button to Proceed
Push any Button to Proceed
Test Types
Azimuth Motor
Elevation Motor
Skew Motor
Antenna Gyro
Internal Sensor
RF Comms
RF Signal
RF Config
Antenna Not
Responding
Get state?
Yes Next Return
State
<Current State>
Push any Button to Proceed
Current State
Initializing
Searching
Tracking
Idle
Error
Figure 3-10
Antenna Status Data Screens