Promise Technology VTrak 15110 - Manual (Page 110)

VTrak 15110 User Manual
102
Telnet
The Service Management–Telnet tab lets you enable and disable Telnet service.
You can use Telnet to run the VTrak Command Line Utility over a network
connection.
To enable Telnet:
1. Click the Subsystem icon.
2. Click on the VTrak icon.
3. Click on the Service Management icon.
4. Click on the Telnet tab.
5. Check the Enable Telnet box.
6. Click the Submit button when you are done.
To disable Telnet, follow the above procedure but uncheckthe Enable Telnet box.
Controllers
Controller List
The Controllers–Information tab lists the controllers for this subsystem. A
Controller is the device that makes your Promise RAID system work. This
information is primarily for reference by Technical Support.
There are no user settings for this tab.
To access the Controllers–Information tab:
1. Click the Subsystem icon.
2. Click on the VTrak icon.
3. Click on the Controllers icon.
Controller
The Controller–Information tab lists the information for a specific controller in this
subsystem. A Controller is the device that makes your Promise RAID system
work. The information listed here is primarily for reference by Technical Support.
There are no user settings on this tab.
• Controller List (below)
• Controller (page 102)
• Settings (page 103)