Promise Technology VTrak 15110 - Manual (Page 63)

Chapter 3: Setup
55
In order to use this logical drive to read and write data, you must partition and
format it using the Host PC’s operating system.
Assign a SCSI Target ID
The term Target ID refers to the SCSI address of the two channels on the RAID
subsystem. A SCSI bus has an Initiator, such as the SCSI card inside the Host
PC, and at least one Target, such as the Controller and Logical Drives inside the
RAID subsystem. Each target must have its own address or Target ID number.
Target IDs can be divided into Logical Unit Numbers (LUNs) to extend the
number of available addresses. The default TID settings for both SCSI channels
is 0. This setting is adequate for most WebPAM and RAID subsystem
configurations. If an address conflict occurs, you might have to change the TID
setting.
You must have Creation Rights to access this function.
To access SCSI Target ID settings:
1. Click on the Subsystem icon in Tree View.
2. Click on the VTrak icon.
3. Click on the SCSI Management icon.
4. Click on the TID Settings tab.
To make settings:
1.
Select the SCSI Target IDs you want to use on SCSI Channel 1.
2. Select the SCSI Target IDs you want to use on SCSI Channel 2.
3. Click the Submit button when you are done.