Promise Technology VTrak 15110 - Manual (Page 191)

Chapter 5: Management with the CLU
183
Maintenance Activity Monitor
The Maintenance Activity Monitor displays the progress of various disk array
operations on the CLU screen approximately every 15 seconds, as shown below.
Daniels Array(DA #1) PDM(4->11) 10%
Daniels Array(DA #1) PDM(4->11) 11%
Daniels Array(DA #1) PDM(4->11) 12%
1. Press 1 and Enter to access the Maintenance Activity Monitor.
Maintenance activity monitor is currently running.
When any maintenance activity occurs e.g. rebuilding,
the maintenance monitor will display notification
message on screen.
Stop maintenance activity monitor(y/n)?>y
Maintenance activity monitor stopped now
Press Enter key to return
2. Press Y and Enter to toggle the monitor between start and stop.
3. Press Enter to return to the Maintenance menu.
Migrate Disk Array
Use this feature to change the RAID mode (level) or a disk array or to add more
physical drives.
1. Type 2 and Enter to access Migrate Logical Drive.
2. Type the ID number for the disk array and press Enter.
*******Physical Drives Selection*******
Id
Name Capacity
----------------------------------------
7
ST3160023AS 159 GB
8 ST3160023AS 159 GB
9 ST3160023AS 159 GB
Enter Physical Drive ids and/or id ranges
separated by commas. For example: 1,5,8-15.
Press R to continue after you have finished
selecting Physical Drives.
Your input?>7,9
3. Type the ID number(s) for the disk drive(s) you want to add and press Enter.
*******Physical Drives Selection*******
Id
Name Capacity
----------------------------------------
*7
ST3160023AS159 GB