Panasonic AG-HPG10P - Manual (Page 35)

35
Playback
Copying clips
Clips can be copied onto the P2 cards in either of the P2 card slots.
• While clips are being copied, do not turn off the power or eject the card. Otherwise, defective clips will be
produced. If defective clips are produced, delete them, and copy the original clips again.
• Copy incomplete clips after having connected them.
1
Display the thumbnail display screen.
2
Select the clip to be copied.
3
Press [MENU].
4
Using [STOP], [PLAY] and [STILL], select
“OPERATION” – “COPY” – “SLOT n” (where
“n” is the number of the P2 card slot into
which the copy destination P2 card was
inserted), and press [STILL].
5
Select “YES”, and press [STILL].
Clip copying now starts.
• To stop the copying process at any time, press
[STILL] to cancel the copying. The partially
copied clip at the copy destination will be deleted.
• If there is a clip with the same GLOBAL CLIP
ID--one which, for instance, was previously
copied to the copy destination--OVER WRITE
will appear. To overwrite the existing clip, select
YES or to cancel the overwriting, select NO,
and press [STILL]. (OVER WRITE also appears
when copying onto the P2 card a different clip
which has been recorded on a multiple number of
cards.)
6
When the completion message has
appeared, press “OK” ([STILL]).
Clips cannot be copied when any of the following
error messages are displayed.
• “LACK OF REC CAPACITY!”
Clips will not be copied because there is
insufficient memory at the copy destination.
• “UNKNOWN CONTENTS FORMAT!”
Clips will not be copied because the selected
clips include defective clips.
• “NO COPY TO SAME CARD!”
Clips will not be copied because an attempt is
being made to copy clips to the same card.
• “TOO MANY CLIPS!”
Clips will not be copied because too many clips
have been selected.