Panasonic AG-HPG10P - Manual (Page 51)

Saving data
51
Copying data from P2 cards to the hard drive (USB HOST mode)
Switching to the USB HOST mode
1
Hold down [POWER] for at least 2 seconds
to turn the power on.
The thumbnail screen now appears.
2
Press [MODE] to display the thumbnail
display off screen.
3
Press [MENU].
4
Using [STOP], [PLAY] and [STILL], select
“OTHER FUNCTIONS” – “PC MODE”, and
press [STILL].
5
Using [STOP] and [PLAY], select
“USBHOST”, and press [STILL].
6
Press [MENU] twice to display the thumbnail
display off screen.
7
Press [MODE] to display the thumbnail
display screen.
8
Hold down [MODE] for at least 2 seconds.
The USB HOST mode is now established,
and “USBHOST” appears at the bottom of the
thumbnail screen.
To exit the HOST mode
1
Hold down [POWER] for at least 2 seconds
to turn off the unit’s power.
The PC mode cannot be released simply by
holding down [MODE].
• While files are being transferred, the power
will not be turned off even when [POWER] is
pressed.
Usable hard drives
The following hard drive can be used.
• Panasonic portable hard disk unit for P2 Store (AJ-PCS060G)
• Any hard drive which can be connected using USB 2.0
• USB bus power (5 V, 0.5 A) is also supported, but some hard drives cannot be started up using it. If this
is the case, supply power from a separate source to the hard drive.
• Hard drives with a memory size of 2 TB or more are not supported.