Panasonic AG-HPG10P - Manual (Page 40)

40
Clip management (continued)
1) Write-protect mark
The mark is displayed when a P2 card is
write-protected.
2) P2 card status
With the remaining memory display, the P2
card’s remaining memory is indicated using
a meter and as a percentage. With the used
memory display, the P2 card’s used memory is
indicated using a meter and as a percentage.
Depending on the status of the card, one of the
following messages may be displayed.
FORMAT
ERROR: An unformatted P2 card has
been inserted.
NOT
SUPPORTED: A card which is not supported
by the unit has been inserted.
NO CARD: A P2 card has not been
inserted.
3) P2 card remaining memory (or used
memory) and total memory
The remaining memory (or used memory) and
total memory of the P2 card are converted
into minutes and displayed. Fractions of a
minute are discarded so that the total of the
remaining memory (or used memory) on each
P2 card may not exactly correspond to the total
memory.
4) Slot remaining memory (or used memory)
total
A figure representing the total for the remaining
memory (or used memory) of the cards in the
two P2 card slots is displayed.
• The free memory of a write-protected P2 card
is not included in the total free memory.
5) P2 card details display
When the cursor is moved to the slot whose
P2 card status is displayed and [STILL] is
pressed, the model number of the P2 card and
other detailed information on the card will be
displayed. When [STILL] is pressed again, the
detailed information is cleared.
The card statuses are displayed as follows.
Displaying the P2 card status (continued)
BRAND
MODEL NO.
SERIAL NO.
USED ID
: Panasonic
: AJ-P2C004HG
: AEC06H0371
:
OK