Panasonic AG-HPG10P - Manual (Page 66)

66
Screen displays (continued)
Error displays
Errors are displayed when trouble has occurred
in the unit, P2 card, etc. If the error persists even
after turning the power off and back on, depending
on what the error message says, replace the card
or contact your dealer.
SYSTEM ERROR
This appears when trouble has occurred in the
system. Turn the system’s power off and then
back on. P2 MICON ERROR (no response from
P2 microcomputer), P2 CONTROL ERROR (P2
control trouble)
TURN POWER OFF
This appears when trouble has occurred because
a card was ejected while its data was being
accessed. Turn the system’s power off and then
back on.
REC WARNING
This appears when trouble has occurred during
recording. Initiate the recording again. If the
warning is still displayed, consult your dealer.
CARD ERR (1) (2) (1/2) (Trouble with the P2
card in the slot corresponding to the number
shown)
• If the warning persists, turn off the power.
• If the warning persists even when recording is
initiated again, replace the existing card with
another one.
REC RAM OVERFLOW
(Recording RAM overflow)
ERROR (Other errors)
CANNOT PLAY
This appears when trouble has occurred during
playback.
CARD ERR (1) (2) (1/2)
(Trouble with the P2 card in the slot
corresponding to the number shown)
CLIP ERROR (Clip trouble)
UPDATING (clip information now being read)
ERROR (Other errors)
1394
This appears when trouble has occurred in the
1394 connection or signals.
1394 INITIAL ERROR (Connection trouble)
1394 INPUT ERROR (OTHER FORMAT)
(Wrong input format)
1394 INPUT ERROR (Input trouble)