Pitney Bowes DM1000 - Manual (Page 141)

10-6 SV60951 Rev. A
10 Troubleshooting
Adhesive Tape
Gets Wet
Wet/dry lever set into wet
position. Set wet/dry lever down to
dry position.
Moistener brush is set too high.
Lever Down For
Dry Position
Remove tape brush
and reset at a lower
position in its holder.
To Lower Brush
Move To The Left
Tape System (continued)
Valve in moistener bottle cap
is not working. Call for service at
1.800.522.0020.
Call for service at
1.800.522.0020.
Low E-Z Seal message is
not working.
Gummed Tape
Not Wet
(continued)
Problem Possible Cause Solution