Pitney Bowes DM1000 - Manual (Page 80)

SV60951 Rev. A 5-17
DM1000 Operating Guide
5
Timeouts:
System Sleep Use this option to specify how long the system can remain inactive before
it goes into “deep-sleep” and removes power from the printer and the
Postal Security Device (PSD).
You can set this timeout for 0 - 1440 minutes, in 1 minute increments. The
default timeout it 30 minutes. The system goes into display sleep before it
goes into system sleep.
The system wakes up again when you press any key on the control center
or if you place mail in the feeder or on the scale (either integrated or
attached external scale).
1. Press the Menu key and select Set Up.
2. Select Basic Settings and then Timeouts.
3. Select System Sleep.
4. Enter the number of minutes (0 - 1440 minutes) using the numeric
keyboard.
5. Press the Enter key.
Timeouts:
Normal Preset
Timer The normal preset timer option allows you to specify how much time you
want to allow the system to remain idle before it returns to the Normal
Preset settings (refer to the Defining Custom Presets section in this
chapter for more information on Normal Presets).
You can set this timeout for 0 - 1440 minutes, in 1 minute increments. The
default timeout is 30 minutes.
1. Press the Menu key and select Set Up.
2. Select Basic Settings and then Timeouts.
3. Select Normal Preset Timer.
4. To set a timeout, enter the number of minutes (0-1440) using the
numeric keyboard.
5. If you want the system to stay at the last settings used, select Never
reset to Normal Preset.
6. Press the Enter key.
13