Pitney Bowes DM1000 - Manual (Page 40)

4
SV60951 Rev. A 4-7
DM1000 Operating Guide
• When printing a meter stamp, you can run sealed flap, open flap and
closed flap mail in the same job run. However, when sealing, you can
run in the same batch only envelopes with:
• open and closed flaps, or
• open flaps and already sealed flaps
• To seal and print:
1. Press the Seal Key.
2. Select Seal and Print.
3. To seal and print:
• open flaps, closed flaps or a combination of the two, select: Flaps
are both Open and Closed.
• open flaps, already sealed flaps or a combination of the two, select
Flaps are Open and Nested.
• To seal only:
1. Press the Seal Key.
2. Select Seal and Print.
Do NOT run already sealed pieces in this mode.
• If the flap depth of your envelope is more than 2 3/4”, you must open
the flap and place it between the feed deck and the rear feed deck
wall. See the figure at right.
• Remove mail from the stacker when full.
Drop Stacker holds up to 200 envelopes.
Power Stacker hold up to 800 envelopes.
The system pauses processing when the stacker is full and restarts
after you empty the stacker.
Feeding Mail
Sealing Mail
Important: You cannot run closed flap and already sealed envelopes
together. The system will rip the already sealed envelopes.
• If you have AutoStart enabled, do NOT place the mail on
the deck until have made all your selections and are ready
to run mail.
• Do not lift any of the covers on the mailing system while the
system is printing or the system stops printing.
Stacking Mail