PictureTel LIVE GATEWAY 3.1 - Manual (Page 25)

this checkbox is enabled (checkmark present in box) LiveGateway will direct all incoming calls to this client for
operator assistance.
Enabling AutoStart
Select this checkbox to automatically start the LiveGateway service on bootup. If this checkbox is not selected,
you must start the LiveGateway service manually from the Windows NT Control Panel Services window upon
server bootup.
Enabling SNMP
Select this checkbox to enable the LiveGateway server’s SNMP extension. SNMP is used to remotely control
the LiveGateway service from the LiveManager console.
Note: SNMP Service under Windows NT is not always installed, although it is available on your
Windows NT Installation CD. Please refer to your Windows NT documentation for further information
on installing the SNMP Service.
Note: Enabling SNMP is recommended. To access a LiveGateway from LiveManager, SNMP must be
enabled and the LiveGateway Service must be started. Otherwise, a system dialog box with the
following message appears, “Cannot connect. Okay to add?”
Exiting Setup
When you have finished entering all of the necessary configuration information, click OK, and the following
screen is displayed.
You can restart LiveGateway now or later. If you click Cancel, the program returns to the LiveGateway
Configuration utility.
If you click Restart Later, the following screen is displayed, which indicates that LiveGateway has been
successfully configured. Your configuration choices will not go into effect until you restart your system.