PictureTel LIVE GATEWAY 3.1 - Manual (Page 68)

I/O Port Base Address Settings
Overview
This appendix lists the I/O Port Base Address settings that can be selected for the LiveGateway board. The
board’s I/O port address is set by DIP Switch, DS-1, which is located just below the BRI module on the board.
The default I/O port base address setting, as configured on the LiveGateway board’s DIP switch for the
LiveGateway board is 380 (hexadecimal). The following illustration shows the default DIP switch settings for
each of the two types of LiveGateway DIP switches used with the LiveGateway board. Your LiveGateway
board will have one of these DIP switches
NOTE:
You can view the DIP switches in this upright way only if the board is
not installed in the PC. When the board is installed in the PC, the DIP
switches appear upside-down.
If the default address conflicts with the I/O address of another device, reset the DIP switches to a different value
before installing the LiveGateway board in the PC. Use a paperclip to change the settings of the DIP switch to
the new I/O port base address.
The following illustration shows an example of how the DIP switch is oriented on the LiveGateway board.
Please note that this illustration shows one of the two types of DIP switches that are used on the LiveGateway
board. Your board may have the other type of DIP switch, but their operation and switch settings are identical.
NOTE:
You can view the DIP switches in this upright way only if the board is
not installed in the PC. When the board is installed in the PC, the DIP
switches appear upside-down.