PictureTel LIVE GATEWAY 3.1 - Manual (Page 6)

3 or 4 200 MHZ Pentium Pro processor with 32 MB of memory (64 MB recommended)
Software Requirements
Your network environment must meet the following minimum software requirements:
• Windows NT 4.0 TCP/IP server
• WinSock 1.1 (or later)
• SNMP service (optional) for managing LiveGateway from the LiveGateway SNMP Manager of the
LiveManager gatekeeper
SNMP Service
Simple Network Management Protocol (SNMP) is a protocol that is available on Windows NT. LiveGateway’s
use of SNMP lets you manage the LiveGateway (installed throughout your network) remotely through the
LiveManager Console. To manage LiveGateway from the LiveManager Console, you need to enable SNMP
service when you install LiveGateway. Refer to
Installing the LiveGateway Software for the instructions for
enabling SNMP service for LiveManager when you install LiveGateway.
Refer to Chapter 2, Installing LiveManager of the PictureTel LiveManager Install Guide for instructions on
how to install the LiveManager Console component of LiveManager on a Windows NT 4.0 (or later) server or a
Windows NT or Windows 95 client.
If you want to manage LiveGateway through the LiveManager Console, but you do not have SNMP service,
contact your network administrator.
ISDN BRI Line
LiveGateway comes ready to connect to an ISDN Basic Rate Interface (BRI) with either National or Custom
ISDN BRI service. You need the following ISDN service, equipment, and information to install LiveGateway:
• ISDN BRI Access
For information about obtaining ISDN BRI access, call PictureTel at 1-800-716-6000, and
request the following documents:
• ISDN Overview (number 3321)
• Contacts for Network Service and Equipment (number 3311)
• A Network Termination (NT1) connected to your ISDN network
Note
If you are connected to a Private Branch Exchange (PBX), check your PBX
requirements. Depending on the type of PBX system you are using, you might
not need an NT1.