PictureTel LIVE GATEWAY 3.1 - Manual (Page 90)

19
No answer from user
(user alerted)
This cause is used when the called party has
been alerted but does not respond with a
connect indication within a prescribed period
of time. Note: This cause is not necessarily
generated by Q.931 procedures but may be
generated by internal network timers.
20 Subscriber absent
This cause value is used when a mobile station
has logged off, radio contact is not obtained
with a mobile station or if a personal
telecommunication user is temporarily not
addressable at any user-network interface.
21 Call rejected
This cause indicates that the equipment
sending this cause does not wish to accept this
call, although it could have accepted the call
because the equipment sending this cause is
neither busy nor incompatible. This cause may
also be generated by the network, indicating
that the call was cleared due to a
supplementary service constraint. The
diagnostic field may contain additional
information about the supplementary service
and reason for rejection.
22 Number changed
This cause is returned to a calling party when
the called party number indicated by the
calling party is no longer assigned, The new
called party number may optionally be
included in the diagnostic field. If a network
does not support this cause, cause no: 1,
unallocated (unassigned) number shall be
used.
26
Non-selected user
clearing This cause indicates that the user has not been
awarded the incoming call.
27
Destination out of
order
This cause indicates that the destination
indicated by the user cannot be reached
because the interface to the destination is not
functioning correctly. The term "not
functioning correctly" indicates that a signal
message was unable to be delivered to the
remote party; e.g. a physical layer or data link
layer failure at the remote party, or user
equipment off-line.
28 I lid b f t Thi i di t th t th ll d t