NEC MAGICOLOR 6110 - Manual (Page 120)

Dual In-Line Memory Modules (DIMMs) 118
The magicolor 6110 has 3 DIMM slots available. The maximum memory that
can be installed is 384 MB.
„
Check the startup page to make sure the printer has enough RAM
installed.
To allocate the default amount of memory to the memory clients, use the
Memory/Quick Config menu to choose the correct resolution and paper
size for your printing (refer to the CrownBook for further information).
If you experience a problem with your magicolor 6110, first go through the
installation procedure in this guide once more. Verify each item thoroughly.
You may also refer to “Troubleshooting” on page 69 for troubleshooting tips.
If you still experience a problem, contact your local vendor or contact Service
(refer to the Service & Support Guide).
Installation
Attention
It’s very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before performing
this procedure, review the antistatic caution on page 113. In addition,
always handle circuit boards by the edges only.
1
If you are not to the point when you are able to print an advanced status
page yet, skip to step 2.
If you have previously installed your printer and have confirmed that it is
printing, print an advanced status page in case you need to restore any
current memory settings after the DIMM installation.
5"
Installing DIMMs automatically restores memory defaults. If your
memory settings are specific to your environment, print an
advanced status page before installing DIMMs, so you can recover
the current memory settings.
2
Ensure that the printer is turned off and the power cord and all interface
cables are disconnected.
Model Standard
Memory Supports up to...
GN 192 MB SDRAM
DIMM 1200 x 1200 dpi simplex printing on all paper
sizes