NEC MAGICOLOR 6110 - Manual (Page 45)

Media 43
Where can I get more information?
See your application documentation for specific information on formatting
data and printing.
Orientation Check your transparency media instructions to confirm if the
media should be placed in the tray long-edge fed with the
non-striped edge first and striped side down.
Type Use any full-color transparencies (also known as OHP film)
that meet normal photocopier standards. We recommend
„ Q-Media Transparency Media for the magicolor 6100
series for color printing
„ 3M CG3700
„
3M CG3710
„ Xerox 3R3117
„ Xerox 3R5764
Weight 24–41.75 lb (90–157 g/m²)
Print Mode
to Select Automatic
Also, select Transparency in the driver.
Duplexing Not supported
Notes „ Remove transparency media as soon as possible from the
output tray to avoid built-up static.
„ If you touch the face of transparencies with your bare
hands, print quality may be affected.
„
Do not handle transparency media too much. Do not fan
transparency media before loading it. Resulting static elec-
tricity may cause printing errors.
„ Keep the media path clean. Transparencies are especially
sensitive to a dirty media path. If there are shadows on
either the top or the bottom of the sheets, see “Cleaning
the Printer Interior” in the Maintenance Guide.
„ You can print continuously with transparencies. However,
this could affect the media feed, depending on the media
quality and printing environment. If problems occur, stop
the continuous print and print one sheet at a time.
„ Use transparencies that can withstand the fusing tempera-
ture (392° F/200° C).