NEC MAGICOLOR 6110 - Manual (Page 148)

SCSI Interface 146
6
Reconnect the power cord, and turn on the printer.
5"
In compliance with UL guidelines, “The appliance inlet is consid-
ered to be the main disconnect device.”
7
Print a startup page.
Check that the startup page lists the interface (Optional NIC) just installed
under “Options.”
Using a Network Interface
Once a network interface is installed, refer to “Connecting the Printer to the
Host Computer,” in the Installation Guide and the CrownBook for information
on connecting to the network, installing the software, and configuring the
interface and the network.
SCSI Interface
The optional SCSI interface allows you to connect up to three optional SCSI
devices, including a hard disk, and Jaz and Zip drives. These devices provide
storage for fonts, emulations, and other files; increase the number of pages
that can be collated; and provide a secondary storage area for spooled data,
while providing virtual memory capabilities.
What's in the Kit?
An optional SCSI interface kit includes the following:
„
SCSI interface card
„
SCSI interface card ribbon cable
„
Connector face plate
„
Two larger screws, two smaller screws
Installation
Attention
It’s very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before performing
this procedure, review the antistatic caution on page 113. In addition,
always handle circuit boards by the edges only.