NEC MAGICOLOR 6110 - Manual (Page 57)

Cleaning the Printer 55
Make sure any parts removed during cleaning are replaced before you plug in
the printer.
Cleaning the Printer
WARNING!
Turn off the printer, unplug the power cord, and disconnect all interface
cables before cleaning.
ACHTUNG! Ziehen Sie den Netzstecker aus der Steckdose bevor Sie
den Drucker reinigen.
Regular cleaning takes only a few minutes and helps ensure printer perfor-
mance and print quality. You need to clean both the inside and outside of the
printer. Keep the following guidelines in mind:
„
Be careful when cleaning the inside or removing paper jams, as the fuser
unit and other internal parts may become very hot. Either clean the printer
before use, or allow time after unplugging it to allow the fuser unit to cool
down.
Attention
The fuser unit is hot. When the top cover is opened, the
fuser unit temperature drops gradually (one hour wait time).
If the printer has a duplex unit installed, always open the duplex
unit’s top cover before opening the printer’s top cover.
„
Use a soft cloth to clean the printer.
WARNING!
Do not spill water or detergent into the printer; otherwise the
printer will be damaged and an electric shock may occur.
ACHTUNG! Verchütten Sie kein Wasser oder andere
Flüssigkeiten auf dem Drucker, da das Gerät sonst
beschädigt wird oder die Gefahr eines elektrischen
Schlages besteht.
„
Never spray cleaning solution directly on the printer’s surface; the spray
could penetrate through the air vents of the printer and damage the inter-
nal circuits.