NEC MAGICOLOR 6110 - Manual (Page 54)

Maintaining the Printer 52
Maintaining the Printer
„
Handle the printer with care to preserve its life. Abuse may cause
damage.
„
Read all caution and warning labels carefully, making sure to follow any
instructions contained in them. These labels are located on the inside of
the printer’s covers and the interior of the printer body.
„
Always close the printer covers gently. Never expose the printer to
vibrations.
Attention
If you have an optional duplex unit installed, always open the duplex
unit’s top cover before opening the printer’s top cover.
„
Lift the printer from the bottom only, using the carrying grips under each
side corner. Make sure two people are available to lift the printer when
moving it.
Attention
Never lift a printer with the fuser oil bottle installed.
„
Do not place anything on the top of the printer.
„
When removing an OPC belt cartridge, you must first open the printer’s
front cover.
Attention
The OPC belt is extremely
sensitive to bright light, direct
sunlight, and touch. Always
leave it in its protective box
until you’re ready to install it.
Any exposure to light should
be limited to less than two minutes, or permanent damage could
result. Also, handle the cartridge carefully so you don’t touch the
surface (the green part) of the belt.
„
Do not leave the printer’s covers open for any length of time, especially in
well-lit places; light may damage the OPC belt cartridge.
„
Do not open any cover of the printer during printing.
„
Do not cover the printer immediately after using it. Turn it off and wait until
it cools down.
„
Do not tap paper stacks on the printer.