Roland SOLJET SC-500 - Manual (Page 39)

37
Incorrect cutting conditions may cause symptoms such as those described below.
Setup for Cutting
For Materials with a Strong Adhesive Layer
If you are using a material with a strong adhesive layer, the adhesive layer may adhere to itself immediately when cut.
This means that even though the material has actually been cut, it may appear as if it has not been cut, and blade force
may mistakenly be set too high.
If a cutting test shows that the material peels easily and the blade traces on the carrier paper are optimal, then the
material is being cut. Take care not to set the blade force excessively high.