When operations are finished – Roland SOLJET SC-500 User Manual
Page 45
43
Even when not in use, keep the machine in an environment where the temperature is 5 to 40 ˚C (41 to 104 ˚F) and
the humidity is 20 to 80 % (no condensation). In particular, be careful to make sure not to expose the machine to
high temperatures of 40 ˚C (104 ˚F) or more.
When operations are finished, move the sheet loading lever toward the back of the unit to raise the pinch rollers.
The pinch rollers may be deformed if allowed to remain in the lowered state.
NOTICE
The SETUP LED goes out
If the SETUP LED is lighted, press the [SETUP] key.
Hold down for about 1 second.
1
Move the sheet loading lever toward the back of the
unit and remove the material.
2
Sheet loading lever
The POWER LED goes out
5
Press the [POWER] key to switch off the power.
The carriage moves to the standby position and the head is capped.
If the carriage is already at the standby position, no movement takes place.
Remove the blade holder from the cutting carriage.
3
Remove the blade.
4
(1) Loosen the tool
securing screw
Press the push-pin
Blade holder
Blade
Carriage
Standby position
When Operations Are Finished
When Operations Are Finished
(2) Remove the blade holder