Roland SOLJET SC-500 - Manual (Page 76)

74
User's Reference
About Blade Life
Cutting conditions and blade life vary according to the hardness of the material and the usage environment. Making the settings for the
conditions described below does not automatically guarantee attractive cutting results in all situations. Before performing actual cutting,
be sure to carry out a cutting test and make any necessary adjustments (see "Setup for Cutting -- Test Cutting").
If the material is not cut through completely even when the tool force is increased by 50 to 60 gf more than the tool force values shown
below, it means that the useful life of the blade has ended. Replace with a new blade.
* The values for life-span are intended to serve as a general guide when cutting materials of identical type.
Amount of cutter
offset
0.25 mm (0.01 in.)
0.25 mm (0.01 in.)
0.25 mm (0.01 in.)
0.25 mm (0.01 in.)
Life of a blade
(General guide)
8000 m
4000 m
4000 m
4000 m
Tool-force
50 to 150 gf
30 to 100 gf
120 to 200 gf
100 to 200 gf
Material
General Signage Vinyl
General Signage Vinyl
Fluorescent Vinyl
Reflective Vinyl
Blade
ZEC-U1005
ZEC-U5025