Roland SOLJET SC-500 - Manual (Page 58)

56
User's Reference
Performing Cutting or Printing at the Desired Location
Set the print or cutting start position (base point) to the desired location.
Load material and install a blade, then press the
[SETUP] key. 1 Use the arrow keys to align the blade with the new
printing or cutting start location (base point). 2
Press the [BASE POINT] key. 3
To release the starting location that has been set...
• Set a new starting location in a different location.
• Press the [SETUP] key to cancel the setup for the material (making the SETUP LED go out).
The BASE POINT LED lights up
When an align point has been set,
it is released if the [BASE POINT]
key is pressed.
Align with
the center
of the blade
installed on
the cutting
carriage.