Roland SOLJET SC-500 - Manual (Page 82)

80
Description of Menu Items
Default
value
Setting
range
Function Submenu
Top
menu
INK
CONTROL
EMPTY
MODE
FILL INK
PUMP UP
HEAD WASH
[EMPTY
MODE]
LATER/
PROMPT
LATER When replacement of the ink cartridge becomes necessary while
printing is in progress, this setting determines whether printing
continues or pauses.
This setting is used when the ink cartridge cannot be changed immedi-
ately during printing, such as during unattended operation at night.
[LATER] causes printing to continue without pause even if ink refilling
becomes necessary. Printing continues with the small amount of ink
remaining, so the printed image may become faint as the ink runs out.
In general, it should possible to perform about 1 m
2 (10 ft 2 ) of printing
once this message appears, although the actual varies widely according
to the amount of ink needed for the particular image. Printing is
continued only for the data currently being printed. Operation stops
after one image is output.
[PROMPT] causes operation to pause immediately when the ink
cartridge needs to be changed. Printing is resumed by replacing the
cartridge and pressing the [PAUSE] key. Please note, however, that the
colors of an image in progress may no longer be perfectly matched if
the unit is allowed to remain paused for two or three hours before
resuming printing.
[FILL INK] : Refills the printing heads with ink. Normally there is no
need to do this, because refilling is automatic.
[PUMP UP] : Drains ink from the printing heads.
[HEAD WASH] : This washes the printing heads with optionally
available cleaning cartridges. For more information, see "Maintenance
- When Moving the Unit... ."
TIME OUT NONE When a certain amount of time passes with no data sent from the
computer, the current output is considered to be finished.
"TIME OUT" sets the time used for this determination. — NONE/
10 to 990 sec.
(In steps of 10 sec.)
FACTORY
DEFAULT
— — — This returns all menu settings to their original values when shipped
from the factory.
For more about the factory defaults for the various settings, see the
"Default value" entry for each menu setting in this section.
PRINT-CUT
ADJ.
TEST
PRINT
FEED
ADJUST
SCAN
ADJUST
—
[FEED ADJUST]
[SCAN ADJUST]
-2.0 to
+2.0 mm
(In steps of 0.1
mm)
—
—
0 mm
—
[TEST PRINT]: This prints a test pattern for adjustment use.
[FEED ADJUST]: This sets the adjustment value for the material-feed
direction.
[SCAN ADJUST]: This sets the adjustment value for the left-right
direction (the carriage-movement direction).
SYSTEM
REPORT
— — — This prints the current status of setting and other system information.
— mm/INCH mm This selects millimeters or inches as the unit of measurement for the
width displayed on the top menu after setting up the material. When
inch display is used, values are displayed to the first digit to the right of
the decimal point. MENU UNIT
ENV.MATCH — This performs automatic adjustment to obtain a state optimized to the
operating environment (temperature and humidity).
For more information, see "User's Reference -- Environment Match-
ing." — —