Roland SOLJET SC-500 - Manual (Page 61)

59
User's Reference
Remove the Printed Material,
then Reload the Material and Perform Cutting
This feature is for performing position alignment in cases where printing is performed, after which the material removed from the
machine for further processing (such as laminating), then again loaded for cutting.
Printable and Cuttable Size and Position
Crop marks are used to align material that has been removed, but when you are printing with crop marks, the area where you can perform
printing and cutting is smaller than the area bounded by the crop marks.
You can easily check the actual size of the area where output is possible without crop marks. While the display shows the area where
output is possible, press and hold the [ENTER] key. The actual size where output is possible is displayed until you release the key.
The position where you cut off the material after printing ends is also important. When you reload the material, a margin of 80 mm or
more from the rear edge of the crop marks is required. When you are separating the material automatically, set [PAGE MARGIN] to 80
mm or more. (See "Setting the Page Margins" elsewhere in this chapter.)
12.5 mm 12.5 mm
1.5 mm 1.5 mm
80 mm
12.5 mm
12.5 mm
Printing/cutting area
of the entire piece of material
: Crop-mark size : Pinch rollers
Printing/cutting area
of the entire piece of material
Area where output is possible
when printing with crop marks
Area where output is possible
when printing with crop marks W1000mm ------
FINE BI-DIR
W 975mm ------
FINE BI-DIR
Area where output is possible
when printing with crop marks
: Crop marks : Pinch rollers
Where to cut the material off