Roland SOLJET SC-500 - Manual (Page 69)

67
User's Reference
Press the [ ] key to make the following screen
appear on the display.
5
Use the [ ] key to choose [FEED ADJUST] or
[SCAN ADJUST].
6
Press the [ ] key to make the following screen
appear on the display.
7
Input the correction value calculated in step (2).
Select the correction value with the [ ] [ ] key,
and press the [ENTER] key.
Repeat steps 6 through 8 and perform [FEED AD-
JUST] or [SCAN ADJUST].
8
CUTTING ADJ.
FEED ADJUST CUTTING ADJ.
SCAN ADJUST
SCAN ADJUST
+0.00% +0.00%
Press the [MENU] key and [ ] key to make the
following screen appear on the display.
1
Press the [ ] key to make the following screen
appear on the display.
2
MENU
OVER PRINT OVER PRINT
NONE NONE
Use the [ ] and [ ] keys to choose the number of
passes (two or three), then press the [ENTER] key.
3
OVER PRINT
NONE 2
When you use the program to set the number of passes for overprinting, the program’s setting takes priority.
The setting made with the control panel for the machine takes effect only in cases where the setting for the number of
overprinting passes is not made with the program.
Performing Overprinting
This prints the same image superimposed over the same location a number of times.
When printing materials such as fabric, colors may not come out well with just a single printing pass. Overprinting can achieve darker
printing results.
You can choose either [2] (two passes) or [3] (three passes) as the number of passes for overprinting.
Performing overprinting may result in ink smudges or stretch the fabric.