Roland SOLJET SC-500 - Manual (Page 51)

49
Maintenance
If the separating knife, replace it with the replacement blade.
Make sure the power to the unit is
off before attempting to replace the
separating knife.
Doing so may result in injury.
Press the [POWER] key to switch off the power. 1 Turn off the main power switch. 2
The POWER LED goes out
Remove the separating knife.
(1) Loosen the screw until it slips out.
(2) Grasp the screw portion, and slowly pull it out in
the direction of the arrow.
* Do not pull back while doing this.
3 Replace with a new knife. 4
Install the separating knife.
(1) Grasp the screw portion and slowly insert it into
the groove.
* Take care to ensure that the knife does not slip
(2) Tighten the screw.
5
Positioning groove
The knife is secured in
place by the magnet.
How to Replace the Separating Knife
Do not touch the tip of the blade
with your fingers.
Doing so may result in injury, and the
cutting performance of the blade will be
impaired.
(2)
(1)
If the blade remains in the carriage, use commer-
cially available tweezers to remove it.
(1)
(2)