Roland SOLJET SC-500 - Manual (Page 50)

48
Maintenance
Replacing the Cutter Blade
Do not touch the tip of the blade
with your fingers.
Doing so may result in injury, and the
cutting performance of the blade will be
impaired.
Remove the blade holder from the cutting carriage.
1 Remove the old blade. 2
(1) Loosen the tool
securing screw
(2) Remove the blade holder
Press the push-pin
Blade holder
Old
blade
Push-pin
Blade holder
New
blade
Replace with a new blade. 3
Loosen
Tool securing screw
Tighten
Cutting carriage
(1) Loosen the tool securing screw on the cutting
carriage.
(2) Support the tool-securing screw from below and
install the blade holder. Insert the blade holder
until the collar is flush with the carriage.
(3) Tighten the tool securing screw until the blade
holder is secured in place.
4