Roland SOLJET SC-500 - Manual (Page 44)

42
Press the [MENU] key and [ ] key to make the
following screen appear on the display.
1
MENU
AUTO SHEET CUT
Press the [ ] key to make the following screen
appear on the display.
2
AUTO SHEET CUT
DISABLE DISABLE
Use the [ ] key to select [ENABLE], then press the
[ENTER] key.
3
AUTO SHEET CUT
DISABLE ENABLE
The material-separating location during
continuous output
Start of the next output
End of output
* When the material-cutting command has not been set to "enabled" at the computer, automatic separation of
the material is not performed, even when the following setting is made.
When sending a material-cutting command from the computer
to separate the material automatically
Remove the Material
35 mm
(1-1/8 in.)
Location where separated 35 mm (1-1/8 in.)
Margin (value set for [PAGE MARGIN])