Roland SOLJET SC-500 - Manual (Page 43)

41
Cut the material from the roll
Either of two methods can be used to separate a portion that's already been cut or printed from the roll. One method is to press the
[SHEET CUT] key. The other method is to perform separation automatically by sending a material-cutting command from the computer.
Remove the Material from the machine
When separating the material by pressing the [SHEET CUT] key
Remove the Material
Press the [SETUP] key. Hold down for about 1
second. 1
The SETUP LED goes out
Move the sheet loading lever toward the back of the
unit.
The pinch rollers rise to release the material. 2
Sheet loading lever
Open the front cover.
To remove the material.
3
Holding down the [SHEET CUT] key for 1 second or longer
severs the material at the present location of the blade tip.
Present location of
the blade tip
Cut or printed
portion
The material is cut off here.
Remove the Material
* This operation isn't necessary when
sending a material-cutting command
from the computer to separate the
material automatically.