Roland SOLJET SC-500 - Manual (Page 63)

61
User's Reference
Use the [ ] key to select [ENABLE], then press the
[ENTER] key.
3 Send the printing data from the computer.
Three crop marks are automatically printed on the left
and right areas at the front edge of the material. 4
* Setting [CROP MARK] to [ENABLE] makes the
output area 25 mm (1 in.) narrower.
Crop marks
Rear
Front
Printing with Crop Marks
Press the [MENU] key and [ ] key to make the
following screen appear on the display.
1 Press the [ ] key to make the following screen
appear on the display.
2
MENU
CROP MARK CROP MARK
DISABLE DISABLE
CROP MARK
DISABLE ENABLE
If you used the program to enable or disable crop marks, then crop marks are printed or not printed according to the
program settings. The setting made with the control panel for the machine takes effect only in cases where the program
does not specify that crop marks are enabled or disabled.
Crop marks are printed bidirectionally. If you have changed the material to a different type or changed the head height,
adjust bidirectional printing. For more information about bidirectional printing, see "User's Reference - Make Correc-
tions for Printing."