Runco DTV-1200 - Manual (Page 14)

RGB Source to Input 3
12
Which signal to Input 3
Connect your RGB source with sync on green, composite or separate sync via an interface to Input 3.
Always use an interface when a computer and local monitor have to be connected to the projector as the signal
cable coming from the computer is limited to 60 cm due to interferences.
Pin configuration D9 connector of the Analog input.
1 Not connected
2 Ground RGBS
3 RED
4 GREEN
5 BLUE
6 Ground RGBS
7 Ground RGBS
8 Hor/comp. sync
9 Vert. sync
Future Expansion
R G B
INPUT 4/5
S-Video
OFF/ON
75 Ohm
INPUT 2
Video
INPUT 1
12 Volt
Trigger H V
OFF/ON
75 Ohm
AC Input
Status
Green: Operation
Red: Standby
OFF ON
INP INP R G
B H V INPUT ANALOG INTERF. 120MHz ON
OFF
inver. 75 ohm term.
Input Select Input 3
With the Remote, press button 3
Which signal to Input 4/5
RGB input terminals with separate H and V Sync inputs, Composite Sync Input or with Sync on green (BNC ter-
minals). The Projector detects automatically where the sync signal is located. This is the Input where Video
Processors (such as the Runco VHD-4404 Ultra) or high definition sources should be connected.
RGB Source with Composite Sync to Input 4/5
Future Expansion
R G B
INPUT 4/5
S-Video
OFF/ON
75 Ohm
INPUT 2
Video
INPUT 1
12 Volt
Trigger H V
OFF/ON
75 Ohm
AC Input
Status
Green: Operation
Red: Standby
OFF ON
M U L T I F I L M
Menu
4404 ULTRA
RUNCO
RGB Sync on green or separate Sync Input selection
With the remote, press:
- Button 4 for Sync on green
- Button 5 for Separate Sync