Runco DTV-1200 - Manual (Page 59)

PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
Select with or
then <ENTER>
<EXIT> to return
PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
Select with or
then <ENTER>
<EXIT> to return
Change Projector Address
What can be done?
Every projector requires an individual address between 0 and 255.
How to change the address?
To change the address, perform the following:
menu 1
PROJECTOR ADDRESS
Enter new projector address:
0 0 0
Use and to select,
and reprogram
with numeric keys.
Highest address is 255
<ENTER> to confirm
<EXIT> to return
menu 2
1. Push the cursor key or to highlight 'Change Projector Address' (menu 1).
2. Press ENTER to select.
The Change Projector Address menu (menu 2) will be displayed and the actual address will be filled in.
The first digit is highlighted.
3. Push the cursor key or to select the digit to be changed.
4. Reprogram with the digit keys on the Remote.
5. Press ENTER to confirm.
Change Baud Rate
What can be set up?
The communication speed between projector and computer has 8 possible speeds.
The baud rate speed can be software set up.
The following baud rates are available: 38400, 19200, 9600, 4800, 2400, 1200.
How to set up?
To set up the baud rate:
1. Push the cursor key or to highlight 'Change Baud Rate' (menu 1).
2. Press ENTER to select. The actual baud rate will be highlighted (menu 2)
3. Push the cursor key or to select the desired baud rate.
4. Press ENTER to accept.
menu 1
BAUD RATE
Select new baud rate :
38400 19200
9600 4800
2400 1200
Select with arrow keys:
<ENTER> to accept
<EXIT> to return.
menu 2
57