Runco DTV-1200 - Manual (Page 18)

13 FREEZ: press to freeze the projected image.
14 TEXT: when adjusting one of the image controls, e.g. contrast, during a meeting, the displayed bar scale
can be removed by pressing 'TEXT' key first. To re-display the bar scale on the screen, press 'TEXT' key again.
15 ENTER: to start up the adjustment mode or to confirm an adjustment or selection in the adjustment mode.
16 Cursor Keys: to make menu selections when in the adjustment mode.or to increase or decrease the analog
level of the image controls when they are first selected.
17 EXIT: to leave the adjustment mode or to scroll upwards when in the adjustment mode.
18 IR Output LED: lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
16
Start Up
Press the Power button on the remote; ensure the main Power button on the rear of the Projector is pressed in.
When this warm up cycle message appears on the screen, the menu offers the possiblity to start with a warm
up period (press ENTER) or to skip this cycle (press EXIT). The number of minutes and the horizontal frequecy
can be programmed in the 'Service mode' under the item 'Projector Set Up'.
Note: This warm up period is built in so that the Projector can quickly reach its operating temperature.
When starting this warm up period, a full white image is shifted on the CRT faceplate to avoid a burn in. Every
30 seconds a text box will be displayed on another place on the screen with the remaining time to go.
The image dimensions can be adjusted with the cursor keys to avoid scanning on the edges of the CRT's.
PROJECTOR WARM UP
A FULL WHITE PATTERN WILL BE
GENERATED FOR x MIN.
FOR IMMEDIATE USE OF THE
PROJCTOR, PRESS <EXIT>
WARNING : SKIPPING THIS
PROCEDURE CAN REDUCE THE
INITIAL PICTURE QUALITY OF THE
PROJECTED IMAGE;
YOU CAN ADJUST THE IMAGE
DIMENSTIONS WITH THE ARROW
KEYS TO AVOID SCANNING ON THE
EDGES OF THE CRT'S;
THIS OPTION CAN BE DISABLED IN
THE SERVICE MENU
with <ENTER>
<EXIT> to return
To interrupt the warm up period:
1
Press EXIT, the warm up menu will be redisplayed with the remaining time indication.
2 Press EXIT again to quit the warm up cycle and to display the source.
Start Up in a Specific Source
When the Projector is in Standby, it can be turned ON with a specific source. To do this, simply press the source
number button (see page 19).
Stationary Image Warning
Do not display a stationary image with full brightness and contrast for longer than 10
minutes, otherwise you risk damage to the CRT's.
!