Runco DTV-1200 - Manual (Page 21)

19
Input selection modes
Source No. Projector Input Remote Button No.
3 RGB 3
4/5 RGB (HV, S.O.G) 4 or 5
4/5 Component Video 6
4/5 RGB with Tri level sync 7
4/5 Component Video with
Tri-level sync
8
Input Selection via the Remote.
With the digit buttons, it is possible to select one of the above input modes.
When the source is selected
When a valid and available source is selected, there will be information displayed on the screen about that
source. This information includes:
- Source number
- Horizontal frequency
- Vertical frequency
When the entry is a non valid source number, a warning appears on the screen: 'input not available'.
When a valid source number is selected, the projector will display this source or it will wait on the selected
source number until the source becomes available. A message 'source not available' will be displayed for a
short time.
When a Video or S-Video source is selected and no decoder is installed, the projector displays the folllowing
message: 'Option not installed'.
Source 02
Fh= 63 kHz
Fv= 60 Hz
WARNING
Input not
available
WARNING
Source not
available
WARNING
Option not
installed!