Runco DTV-1200 - Manual (Page 61)

PROJECTOR WARM UP
WARM UP : ON
FREQUENCY : 64 kHz
TIME : 15 min
A FULL WHITE PATTERN
WILL BE GENERATED AT
POWER UP
AFTER THIS PROCEDURE
THE PROJECTOR IS READY
TO PERFORM IN OPTIMUM
CONDITION
with <ENTER>
<EXIT> to return
PROJECTOR WARM UP
WARM UP : ON
FREQUENCY : 64 kHz
TIME : 15 min
A FULL WHITE PATTERN
WILL BE GENERATED AT
POWER UP
AFTER THIS PROCEDURE
THE PROJECTOR IS READY
TO PERFORM IN OPTIMUM
CONDITION
with <ENTER>
<EXIT> to return
59
Warm Up Frequency
What can be done?
The line frequency of the white pattern on which the warm up will be executed, can be entered by selecting out
of the displayed list an available block. It is recommended that the Warm up frequency be the same as the input
signal, if possible.
How to install a warm up frequency ?
1. Push the cursor key or to highlight 'Frequency' (menu 1).
2. Press ENTER to display the projector warm up frequency selection menu (menu 2).
3. Select a block with the cursor keys.
4. Press ENTER to copy the settings of the selected block to the warm up block.
5. Press EXIT to return.
menu 1
PROJECTOR WARM UP
Nr. Src Fh Fv inp conf
1 1 15.6 50 video FC
2 3 31.2 60 RGB3S RT
3 - 15.6 50 intern FC
4 2 31.5 50 RGB3S FC
5 - 33.7 60 intern FC
6
Active block nr. 1
Select block to copy data from with or
<ENTER> to copy settings to warm up block.
<EXIT> to return.
menu 2
Projector Warm Up Time
What can be done?
The warm up time can be programmed with the cursor keys.
How to program the warm up time?
1. Push the cursor key or to highlight 'Time' (menu 1).
2. Press ENTER to display the projector warm up time menu (menu 2).
3. Use the cursor keys to select the first digit and reprogram with the numeric keys.
Repeat for the other digits.
The projector warm up time is given in minutes.
menu 1
PROJECTOR WARM UP
Enter new time :
15 min
Use and to select
and reprogram
with numeric keys
<ENTER> to confirm
<EXIT> to return menu 2