Runco DTV-1200 - Manual (Page 55)

SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
VOLTAGE DIAGNOSTICS
PROJECTOR DIAGNOSTICS
Select with or
then <ENTER>
<EXIT> to return
53
SERVICE MODE
Start Up
1. Push the cursor key or to select to SERVICE (menu 1).
2. Press ENTER to select.
The service menu will be displayed (menu 2). Some items in the Service mode are password protected
(when the password function is active). Enter your password to continue. All other password protected items
are now also available if you stay in the adjustment mode.
Service Mode
ADJUSTMENT MODE
Select a path from below:
RANDOM ACCESS
INSTALLATION
SERVICE
source 1
Select with or
then <ENTER>
<EXIT> to return
menu 1 menu 2
Overview Flowchart
SERVICE MODE
PROJECTOR SET UP
PROJECTOR DIAGNOSTICS
MEMORY MANAGEMENT
COMMON SETTINGS
VOLTAGE DIAGNOSTICS
I2C DIAGNOSTICS
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE
COMMON ADDRESS
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
SET TO MIDPOSITION
DYNAMIC ANTIGMATISM
CRT RUN IN CYCLE
GAMMA CORRECTION
MEMORYBANKS: ON
MENU POSITION: STANDARD
CRT DRIVE MODE
FLYBACK TURNOVER POINT