Runco DTV-1200 - Manual (Page 15)

13
RGB Source with Tri-level Sync to Input 4/5
Which signal to Input 4/5
RGB input terminals with Tri level sync input or with Tri-level sync on green (BNC terminals). The projector
detects automatically where the sync signal is located.
RGB3S or RG3sB input selection
With the remote, press digit button 7
Component Source to Input 4/5
Which signal to Input 4/5
(R-Y)Y(B-Y) input terminals with sync input or with sync on the luminance (Y) input (BNC terminals). The pro-
jector detects automatically where the sync signal is located.
Component Video input selection
With the remote, press digit button 6
RS-232 Connection
RS-232 input and RS-232 output of the Projector.
The projector is equipped with a RS-232 port that allows communication with an automation system such as
AMX, Crestron, etc.
Applications
a) remote control:
- allow storage of multiple projector configurations and set ups.
- wide range of control possibilities.
- address range from 0 to 255.
b) data communications:
- sending data to the projector or copying the data from the projector to a hard memory device.
Set up of the Baud Rate for Communication with a Computer.
See 'Changing the Baud Rate' in chapter 'Service Mode'.