Runco DTV-1200 - Manual (Page 74)

COMMON SETTINGS
DYNAMIC ASTIGMATISM
GAMMA CORRECTIONS
CRT RUN IN CYCLE
CRT DRIVE MODE
MEMORYBANKS : ON
FLYBACK TURNOVER POINT
MENU POSITION : STANDARD
Select with or
then <ENTER>
<EXIT> to return
COMMON SETTINGS
DYNAMIC ASTIGMATISM
GAMMA CORRECTIONS
CRT RUN IN CYCLE
CRT DRIVE MODE
MEMORYBANKS : ON
FLYBACK TURNOVER POINT
MENU POSITION : STANDARD
Select with or
then <ENTER>
<EXIT> to return
72
Start Up
To start up the gamma corrections :
1. Push the cursor key or to highlight 'Gamma Corrections' (menu 1).
2. Press ENTER to start up. A warning screen will be displayed (menu 2).
Gamma Corrections
menu 1
WARNING
RISK OF INCORRECT ADJUSTMENT
OF THE PROJECTOR
THE GAMMA CORRECTIONS ARE
FACTORY ADJUSTED USING COLOUR
ANALYSER! THEREFORE, ONLY
QUALIFIED INSTALLATION OR SERVICE
PERSONNEL SHOULD PERFORM
THESE ADJUSTMENTS !
<ENTER> TO CONTINUE
<EXIT> TO RETURN
menu 2
CRT Run In Cycle
What can be done?
Only necessary when a new picture tube is installed or when CRT arcing continues. The CRT run in cycle
option can only be activated when memory blocks on an internal # pattern are available. When one or more
such blocks are available, a flashing white image (5 sec on, 5 sec off) is generated and then for 5 min on the
first internal block. In the next 5 min, a second internal block will be used to generate the flashing white image.
The image will also be shifted in a vertical way to prevent a CRT burn in. To quit the CRT run in cycle option,
press EXIT.
How to select CRT run in cycle?
1. Push the cursor key or to highlight 'CRT run in Cycle' (menu 1).
2. Press ENTER to start up. If a memory block adjusted on an internal # pattern is available, the CRT run in
cycle will start. If no such a block is available, the projector cannot run the CRT run in option and leaves the
adjustment mode. If you still want to run CRT run in cycle, create first a memory block on an internal #
pattern and restart the CRT run in option.
menu 1
CRT RUN IN CYCLE
A flashing white pattern will be
generated until <EXIT> is pressed.
The projector only uses memory
blocks adjusted on an internal
# pattern; if no such block is
available, the projector can't run
the procedure and leaves the
adjusment mode.
<ENTER> to continue
<EXIT> to cancel
menu 2