RAD Data comm IPmux-1 - Manual (Page 10)

Chapter 1 Introduction IPmux-1/1E Installation and Operation Manual
1-2 Overview
Applications
Typical IPmux-1/1E applications are shown with E1/T1, ISDN, and FXS interfaces.
Figure 1-1 illustrates Multiplexing Voice and Data over an Ethernet Trunk.
Figure 1-2 shows an E1/T1 circuit extension over an IP based Network.
Figure 1-3 illustrates mixed BRI and POTS support application of V5.1
concentration of BRI remote terminals.
Figure 1-4 shows mixed BRI and POTS support application of S/U interface
concentration.
Figure 1-5 illustrates extending BRI ports and LAN of a Small Office.
Figure 1-6 shows Ethernet-based multi-tenant with voice and data integrated
access.
10/100
Mbps 10/100
Mbps E1/T1 E1/T1
IPmux-1 IPmux-1
Ethernet
PBX PBX
SITE A SITE B
Ethernet
Switch Ethernet
Switch
Figure 1-1. Multiplexing Voice and Data over an Ethernet Trunk
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com