RAD Data comm IPmux-1 - Manual (Page 51)

IPmux-1/1E Installation and Operation Manual Chapter 3 Operation
Operating Instructions 3-5
6. Press <Esc> to open the configuration software.
7. Enter your User Name according to your assigned system privileges (either
Supervisor (su) or User and then your Password when prompted (the
factory-set password is xxxxxxxxxx).
The Main Menu is displayed (Figure 3-8).
If the password is invalid in three consecutive attempts, the system becomes
inaccessible for 15 minutes.
Login
User Name and Password
➤
To enter as a superuser:
1. Enter su for User Name.
2. Enter xxxxxxxxxx for Password.
This allows you to configure all the parameters of Ipmux-1/1E, and to change the
su and user passwords.
➤
To view the unit’s comfiguration:
1. Enter user for User Name.
2. Enter xxxxxxxxxx for Password.
This does not allow you to make configuration changes.
➤
To set all passwords to the default value (xxxxxxxxxx ):
• Delete the unit’s configuration through the Configuration screens.
Deleting the unit’s configuration using <Cntl+A> and choosing 4 in the Boot
Menu does not set the password to the default value.
➤
If you forget your password:
• Consult Technical Support at RAD for further assistance (send email to
[email protected]).
Turning IPmux-1/1E Off
➤
To power off the unit:
• Switch PWR to OFF.
Note
Note
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com