RAD Data comm IPmux-1 - Manual (Page 42)

Chapter 2 Installation IPmux-1/1E Installation and Operation Manual
2-6 Installation and Setup
100-240
V
A
C
1A
T
250V
POW ER
I/O
3 : CAUTION IIS D N
S
1 2 3 4
Figure 2-9. IPmux-1E Rear Panel (BRI Option) for Two Ethernet Ports
Grounding
Interrupting the protective grounding conductor (inside or outside the instrument)
or disconnecting the protective earth terminal can make this instrument
dangerous. Intentional interruption is prohibited.
Before switching ON this instrument and before connecting any other cable,
the protective earth terminals of this instrument must be connected to the
protective ground conductor of the power cord.
Fuses
Make sure that only fuses with the required rated current and specified type, as
marked on the IPmux-1/1E rear panel, are used for replacement: 1.6A T 250V.
Whenever it is likely that the protection offered by fuses has been impaired, the
instrument must be made inoperative and secured to prevent any operation.
Location of Connectors
Interface connections are made from the IPmux-1/1E back panel, as shown in
Figure 2-2.
• Table 2-1 lists the E1/T1 port pinout.
• Table 2-2 lists the Ethernet port pinout.
• Table 2-3 lists the Control port pinout.
• Table 2-4 lists the ISDN-S connector pinout.
• Table 2-5 lists the FXS connector pinout for RJ-11.
Warning
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com