RAD Data comm IPmux-1 - Manual (Page 125)

IPmux-1/1E Installation and Operation Manual Appendix E Parameters and Screens
LAN Configuration (no User port) E-27
E.8 LAN Configuration (no User port)
For LAN configuration for two LANs, see Ethernet Configuration/Statistics Menus.
LAN CONFIGURATION
1. Auto Negotiation Enable
2. Max Capability advertised 100baseT Full Duplex
3. Default type 100baseT Full Duplex
ESC. Exit
Select item from the menu.
Figure E-27. LAN Configuration Menu
Table E-19. LAN Configuration Parameters
Parameter Possible Values Remarks
Auto Negotiation Enable, Disable Auto Negotiation mode is according to RFC 2239
Default: Enable
Maximum Capabilities
Advertised Maximum Capabilities of the port for the Auto
Negotiation process (can be lower then the actual
capabilities)
Default: 100baseT Full Duplex
Default Type 10BaseT Half Duplex,
10BaseT Full Duplex,
100BaseT Half Duplex,
100BaseT Full Duplex Default: 100baseT Full Duplex
Note: This parameter is valid only when the Auto
Negotiation mode is disabled (RFC 2239).
If Auto Negotiation is set to Enable and you experience some incompatibility in the
Auto Negotiation process, set Auto Negotiation to Disable and set Default type to
the desired mode.
When the physical port is fiber, the operation mode is:
Auto Negotiation Off//full duplex/100 Mbps. This is the only possible setting.
Main Menu
↓
2. Configuration
↓
4. LAN
Configuration
Note
Note
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com